FreeBarbequeCartPlans.Com
Welcome to another FREE Woodworking Resource sponsored by your fellow
woodworkers at Shopsmith

Index

Page 1 2 3 4 5

The Roll-Around Barbeque Cart
 

Step 1: First, cut all workpieces to size, following the dimensions outlined in the List of Materials.

NOTE:  Be sure to allow all glued-up sub-assemblies to dry completely for 24 hours before putting them together with other sub-assemblies.

Step 2:
Using your drill press, drill (16) 3/8-inch diameter by 9/16-inch deep dowel holes in pieces B, C and D, and glue the  facing assembly together, using  3/8-inch diameter by 1-inch long dowel pins as shown in Figure 1.

Step 3: Use your dado set-up or bandsaw to cut a 10-7/16-inch wide by 1-9/16-inch deep notch in the left side of the base assembly (F) to accommodate the pull-out shelf/cutting board, which will be installed later. See Figure 2.

Step 4: Drill (50) 3/8-inch diameter by 9/16-inch deep dowel holes in pieces A, E, F and G as shown in Figure 2.  Assemble all pieces together (including the facing sub-assembly you made in step #2, above) using 3/8-inch diameter by 1-inch long dowel pins.

Figure 1 Figure 2

 

Continue . . .

Send For Your FREE Woodworking Fact Kit and "Sawdust Therapy" TV Show.

First Name*:
Last Name*:
Street Address*:
 
City*:
State*:
Zip*:
Country*:

USA Canada
Other

E-mail Address*:

  2009 Shopsmith Inc. All rights reserved.

  Policies | Contact Us | Links | Corporate Web Site